Load Indicator

Load Indicator

Leveraging on our vast industry experience and knowledge, we have engaged in manufacturing and supplying high quality Load Indicator.Standardized EDP command sets

•  Water-resistant enclosure
• Configurable analog to digital measurement rate
•  Universal mounting stand

  GENERAL SPECIFICATIONS OF THE UNIT ARE AS FOLLOWS.

• Dimension : Outer: 96 mm (W) x 48 mm (H) x 110 mm (D)
• Cut-out: 92 mm (W) x 44 mm (H)
  
• On board 24-bit ADC is provided for Digitizing Analog Input.
• Filtering:Analog & Digital
• Sampling speed:15 readings/second
• Power Supply:24 VDC
• Input:4-wire Load cell, Up to Four Single Load cell with 300 Ohms Resistor
• Remote input:for GROSS/NET, TARE and Zero functions
• Display:6-digit 7-segment 0.56" Red LED
• Decimal position: Selectable.

Key Board: Four keys membrane like Programmable Parameters:

• Decimal Point,
• Capacity,
• Display Resolution,
• Grad,
• Zero Track Band,
• Zero Range
• Configuration Data are stored in serial NVRAM, Battery back up not required
• Calibration through software (Offset: ' Z '& Span: ' S ' stored in NVRAM)
• Optional:Serial Port for communication with the remote display/Printer/Computer using RS-485/RS-232
• Outputs:One Digital output (opto isolator)
• Retransmission:4-20 mA/0-10V Proportional indicated weight
• Enclosure:Plastic, General Purpose, Panel Mounting type